This article is for general education and isn't a substitute for medical advice or your device's instructions. Always follow the cleaning procedures recommended by your CPAP mask manufacturer.
Key Takeaways
The Paptizer 360 is an FDA 510(k)-cleared UV-C LED device that reduces bacteria on certain compatible home-use CPAP mask cushions after cleaning.
In laboratory testing, The Paptizer 360 demonstrated an in vitro 2-log (99%) bacterial reduction after a complete cycle against six common bacteria.
It's a post-wash step, not a replacement — it does not replace the cleaning procedures recommended by your CPAP mask manufacturer.
The Paptizer 360 runs a single 30-minute cycle, at the press of one button, does not use an ozone process, and is FSA/HSA-eligible under code 9274.
The Paptizer 360 is a targeted way to reduce bacteria on your CPAP mask cushion after you wash it. It runs a single 30-minute UV-C cycle at the press of a button, and it's built for the part of your setup that collects the most bacteria: the cushion that rests against your face. Here's a quick look at what it does and why it fits into a clean CPAP routine.
How It Fits Your Routine
The Paptizer 360 is a post-wash step, not a replacement for cleaning. You wash the mask cushion with a bubble pad or soap and water, let it air-dry, then run it through a 30-minute cycle for an added measure of bacterial reduction. For the full cushion-cleaning routine, see our complete guide to CPAP mask cushion cleaning and bacterial reduction.
Does not replace the cleaning procedures recommended by your CPAP mask manufacturer.
Simple and Safe to Use
One button starts the cycle, and an LCD display counts down the 30 minutes. The device uses a 40-light UV-C LED array and does not use an ozone process. If the lid is opened during a cycle, the UV-C lights switch off automatically to prevent exposure to eyes or skin. It processes one mask cushion at a time and is intended for single-patient home use by adults.
What the Testing Shows
In laboratory testing, the Paptizer 360 demonstrated an in vitro 2-log (99%) bacterial reduction after a complete cycle against six common bacteria: Staphylococcus epidermidis, Staphylococcus aureus, Klebsiella pneumoniae, Pseudomonas aeruginosa, Escherichia coli, and Streptococcus pyogenes.
An in vitro 2-log (99%) bacterial reduction has been demonstrated after a complete processing cycle. Tested with ResMed AirFit F20 mask cushions. Any correlation between in vitro results and clinical outcome has not been established.
Frequently Asked Questions
What is the Paptizer 360?
It's an FDA 510(k)-cleared UV-C LED device that reduces bacteria on certain compatible home-use CPAP mask cushions after cleaning.
How does it reduce bacteria?
A 40-light UV-C LED array runs a single 30-minute cycle. In laboratory testing it demonstrated an in vitro 2-log (99%) bacterial reduction after a complete cycle.
An in vitro 2-log (99%) bacterial reduction has been demonstrated after a complete processing cycle. Tested with ResMed AirFit F20 mask cushions. Any correlation between in vitro results and clinical outcome has not been established.
Does it replace cleaning my mask?
No. It's a step you add after washing, never a replacement for it.
Does not replace the cleaning procedures recommended by your CPAP mask manufacturer.